Minolta Di152 183 Memory Full, Press ANY KEY, ∗Pc Print∗, SET PLUG-IN Counter, Upper Tray Full

12

Error Messages

Message		Cause		Remedy
MEMORY FULL		The size of the data for the		Press the [Panel Reset] key,
	(Flashing alternately)	scanned image has		or turn the machine off, then
		exceeded the capacity of the		on again. (The scanned data
PRESS ANY KEY		memory.		should be cleared from the
				memory.)
∗PC PRINT∗		The image data received		Press the [Panel Reset] key,
MEMORY FULL		from the computer has		or turn the machine off, then
		exceeded the capacity of the		on again. (The received
		memory.		image data should be cleared
				from the memory.)
SET PLUG-IN COUNTER		A counter key is not inserted.		Insert the counter key.
UPPER TRAY FULL		If the optional Job Tray is		Remove all paper from the
	(Flashing alternately)	installed and the paper in the		Upper Copy Tray of the Job
		Upper Copy Tray has		Tray.
REMOVE PAPER		reached the maximum
		capacity, printing cannot
		continue.
TRAY MOVEMENT		The optional Job Tray is		Remove the paper from the
ERROR		installed and the paper in		Upper Copy Tray or the
	(Flashing alternately)	either the Upper Copy Tray or		Lower Copy Tray of the Job
		the Lower Copy Tray has		Tray, and then press the
PRESS ANY KEY		reached the maximum		[Panel Reset] key.
		capacity when the machine is
		turned on, when copying
		begins, when receiving a fax,
		or when starting to print.
LINE PROBLEM		•	The telephone dialing	•	Check the telephone
	(Flashing alternately)		system or telephone wiring		dialing system or
			system are not set		telephone wiring system
CHECK LINE			correctly.		and use the appropriate
		• The telephone cable is not			Utility mode function to
			attached correctly.		make the correct settings.
				•	Correctly connect the
					telephone cable.
∗COMM.ERROR∗		•	Communication is not	Check the transmission
(####)			possible because of some	results.
			problem in the machine.
		•	Communication is not
			possible because of a
			problem with the recipient/
			caller’s fax machine.
∗REDIAL ALL FAILED∗		All redial attempts failed		Check the condition of the
		because either the recipient’s		recipient’s line, and then try
		line is busy or there was no		sending the fax again.
		answer.
∗MEM.FULL/TX CANCEL∗		While sending a fax, the size		• Retrieve all received faxes
		of the data for the scanned			stored in the memory.
		image has exceeded the		• Send the fax by direct
		capacity of the memory.			transmission.
∗MEM.FULL/RX		While receiving a fax, the size		Retrieve all received faxes
CANCEL∗		of the data for the scanned		stored in the memory.
		image has exceeded the
		capacity of the memory.

12-20 Di152f/Di183f