12-4 User’s Reference Guide
You should set the Netopia R2020’s seeding action to work best in your particular network environment. These scenarios may guide you in deciding how to set the router’s seeding:
■If the Netopia R2020 is the only router on your network, you must set it to either hard seeding or soft seeding. The default is soft seeding.
■If there is another active router on your network, and you want that router to configure the Netopia R2020’s EtherTalk or LocalTalk parameters, you can set the Netopia R2020 to
■If there is another active router on your network, you could set the Netopia R2020 to be soft seeding if you are unsure that the second router would always be available to configure the Netopia R2020’s EtherTalk or LocalTalk parameters.
■If you want the Netopia R2020 to configure the EtherTalk or LocalTalk parameters of other routers on your network, you must set it to hard seeding. In this case, the other routers must be soft seeding or
■If you want the Netopia R2020 and all other routers on your network to use only their own configurations, set the Netopia R2020 and all other routers to hard seeding. In this case, any router (including the Netopia R2020) that is rebooted will not begin routing if it detects a routing conflict between itself and any other router. This last scenario could be useful for detecting and locating routing errors on your network.
Installing AppleTalk
The AppleTalk kit consists of hardware and firmware components that you enable on your router in order to connect an AppleTalk network. The LocalTalk connector supplied in the AppleTalk feature expansion kit cable connects to the Auxiliary port on the Netopia R2020.
Netopia R2020 back panel
Ethernet
8 7 6 5
4 3 2 1
Line 2 | Auxiliary | Console | Line 1 | Power |
Normal/Uplink
1
Auxiliary connection port
You then enable AppleTalk routing through the
To install the AppleTalk features from the Main Menu, go to System Configuration and select Upgrade Feature Set.
