Chapter 5 Setting up skillsets 45

AC Entry: OPT

OPT PRMPT NEXT

EWT sample: 10

CHNG NEXT

EWT allow incr: Y

CHNG NEXT

EWT ICD: 00:03:00

CHNG NEXT

Mo: 24 hour

CHNGNEXT

Day start: hhmm

RETRYOK

Day hhmm: xxxx

RETRY AM PM

Night start: hhmm

RETRYOK

Night hhmm: xxxx

RETRY AM PM

26Press NEXT if your Call Center does not use Activity Codes and go to step 27

or

if your Call Center uses Activity Codes, select the Activity Code entry type: OPT for Optional, PRMPT for Prompted and press NEXT. This prompt appears only if you have Call Center Reporting enabled on your system.

NOTE: Although you can set this Activity Code parameter by telephone, you must use CallPilot Manager to create Activity Codes. For more information, refer to the Call Center Set Up and Operation Guide or CallPilot Manager online help.

27If you use Expected Wait Time, enter how many calls you want to use to calculate ETW. The range is 2-256 calls. The default is 10.

If you do not use Expected Wait Time, go so step 30.

28If you use Expected Wait Time, select whether you want EWT to be recalculated if it increases, and the appropriate EWT greeting to be played. The default is Y.

29If you use Expected Wait Time, enter the Initial Call Duration. This can be a value between 00:01:00 and 24:00:00, and is used to compute expected wait time until sufficient statistics are obtained The default of 3 minutes is shown.

Press CHNG if you want to change the default or

press NEXT to accept the default time and go to step 30.

30Press CHNG to change the service mode for Monday or

press NEXT.

31Enter the Day Routing Table start time and press OK.

This is a four digit field. Add a zero to any single digit hour or minute.

32Press AM or PM.

33Enter the Night Routing Table start time and press OK.

This is a four digit field. Add a zero to any single digit hour or minute.

34Press AM or PM.

Call Center Telephone Administration Guide

Page 45
Image 45
Nortel Networks Call Center Telephone manual OPT Prmpt Next