Ricoh AP305 operating instructions Installing Network Interface Board Type305

Installing Network Interface Board Type305

Installing Network Interface Board Type305

RCAUTION:

•Make sure to turn off the printer and wait for about 30 minutes before installing options. Not waiting for the printer to cool down can result in a burn.

Note

❒Use a shielded twisted-pair (STP) network interface cable.

❒The network interface board can be attached to either the left or the right side of the back of your print- er. This procedure is for attaching to the left side.

❒You cannot install two network in- terface boards at a time.

A Check the contents of the box for the following items.

•Network interface board

•Ferrite core

•Installation Guide

B Turn off the printer's power switch and remove all cables and cords from the printer.

C Remove screws and remove the left back plate.

Note

❒A coin can be used to remove the screws.

D Insert the network interface
	2
board into the slot and fasten it
with screws that were removed in
step C, as shown in the illustra-
tion.

TFWP040E

Note

❒A coin can be used to fasten the screws.

E Loop the network interface cable. The loop should be about 15 cm (6”) from the end of the cable on the end closest to the printer.

F Attach the ferrite core to the loop.

TFWX980E

TFWX185E

15