Ricoh AP305 operating instructions 191.168.015.016 j, System Menu Net Boot, Net Boot None

Configuring the Printer for the Network with the Operation Panel

G Repeat steps E and F to spec- ify the rest digit of the IP ad- dress.

191.168.015.016 j

Check if the pointer (U) is at the rightmost digit, press {Enter} to register the IP address you spec- ified.

<System Menu> j 32.IP Address l

F If you use TCP/IP, you should as- sign “33.Subnet Mask”, “34. Gate- way Add”, “35.Access CTL” and “36.Access Mask” using the same procedure for specifying the IP address. ⇒ P.26 “Address”

G If you use TCP/IP, you should make settings for “37.Net Boot”.

You can select how to assign the printer's address using the com- puter. Select one of items on the ta- ble below.

Menu item on	Available method
the panel display
	AR *1	RA *2	BO *3	DH *4
ARP+PING	'
ARP & RARP	'	'
ARP & BOOTP	'		'
APR & RARP & BOOT	'	'	'
None (Default Setting)
RARP+TFTP		'
BOOTP			'
RARP & BOOTP		'	'
DHCP				'

*1 ARP+PING

*2 RARP+TFTP

*3 BOOTP

*4 DHCP

Note

❒You should set up your server, if you want to use “RARP+TFTP”, “BOOTP”, or “DHCP”.

A Press {U}{T} until the follow- ing message appears.

<System Menu>	j
37.Net Boot	l	3

BPress {Enter}.

The current setting appears on the panel display.

<Net Boot>	j
*None	l

C Press {U}{T} until the method you want to use appears.

DPress {Enter}.

H If you use NetWare, select the frame type for NetWare.

Select one of items below if neces- sary.

•Auto Select (Default)

•Ethernet 802.3

•Ethernet 802.2

•Ethernet2

•Ethernet SNAP

Note

❒Usually, use the default setting (“Auto Select”). However if you select “Auto Select”, the frame type detected by the printer first is adopted. If your network can use more than two frame types, the printer may fail to select the correct frame type, if the “Auto Select” is selected. In this case, select the appropriate frame type.

25