|
| Error & Status Messages |
|
|
|
Message | Description | Comments |
|
|
|
94:Error | The amount of the memory | Specify the correct memory |
| is not set correctly. | capacity using the printer |
|
| driver. Windows 95/98 ⇒ |
|
| P.35 “Setting Up Options”, |
|
| Windows 3.1x ⇒ P.38 “Set- |
|
| ting Up Options”, Windows |
|
| NT4.0 ⇒ P.41 “Setting Up |
|
| Options” |
|
|
|
Note
❒If you cannot solve the problem by taking above actions, turn the printer power off and then back on again. If this does not clear the error message, write down the error number and the message, and contact your sales or ser- vice representative.
Getting Printer Information over the Network
Note | 6 |
❒ The optional network interface board is required to get the information over | |
the network |
|
Printer Current Status
You can check the printer's current status using the following method.
❖UNIX
Use the lpq command or stat parameter of rsh, rcp, or ftp.
❖mshell
Use status command.
Message | Description | Comments |
|
|
|
Ready | Printer works properly. | — |
|
|
|
Add Fuser Oil | The fuser oil bottle is emp- | Replace the fuser oil bottle. |
| ty. | ⇒ P.90 “Replacing the Fuser |
|
| Oil Bottle and Ozone Filter” |
|
|
|
Call Service | There is malfunction in the | Turn the printer off and |
| printer. | then on. |
|
| If this doesn't clear the |
|
| problem, contact your sales |
|
| or service representative. |
|
|
|
Change Fusing Unit | The fusing unit is at the end | Contact your sales or ser- |
| of its life. | vice representative. |
|
|
|
61
