Note
•If a message asking you to select a country appears, select a country first, then the setting a color standard message will appear.
•If you press Cancel, this message will appear again the next time you turn the machine’s power on.
•The machine should be in a ready mode to set the color standard. If the machine is in use, a pop up informing you a job is in a pending state will appear. Press Retry to retry or press Cancel to try it later.
3After a moment a message asking you to print a pattern paper will appear.
Press Print. Pattern printing will start.
Note
There should be a white paper in the tray to print a pattern paper.
4When pattern paper is printed out, place the pattern paper on the scanner glass and press Scan.
Make sure to align the arrow on the pattern paper with the arrow on the coner of the scanner glass.
5When setting a color standard completed message appears, press Close.
Note
You can also use Setting Color Standard menu to set the color standard anytime you want.
1Press Machine Setup on the control panel.
2Press Admin Setting > Setup > Color > Auto Color Tone Adjustment > Setting Color Standard( You can only select this option if Auto Color Tone Adjustment is set to On).
Setting up the network
You need to set up the network protocols on the machine to use it as your network printer. You can set up the basic network settings with the machine's touch screen.
Note
If you want to use the USB cable, connect the cable between a computer and you machine. Refer to the software installation in Software section.
Supported operating systems
The following table shows the network environments supported by the machine:
Item |
| Requirements |
|
| |
Network interface | 10/100/1000 | |
|
|
|
Network | • | Windows 2000/XP/2003/2008/Vista/7/2008 R2 |
operating system | • | Various Linux OS |
| • Mac OS X 10.3 ~ 10.6 | |
|
|
|
Network | • | TCP/IP on windows |
protocols | • | DHCP |
| • BOOTP | |
|
|
|
Note
If you want to set up DHCP network protocol, go to http:// developer.apple.com/networking/bonjour/download/, select the Bonjour program that is appropriate for your computer operating system and install the program. This program will allow you to set network parameters automatically. Follow the instructions in the installation window. This program does not support Linux.
Configuring network protocol via the machine
You can setup TCP/IP Network parameters please follow the steps listed below.
1Make sure your machine is connected to the network with an
2Make sure you turned on the machine.
3Press Machine Setup on the control panel.
4Press Admin Setting.
5When the login message appears, enter password. Touch the password input area, then the question marks appears. Use the number keypad on the control panel to enter the password. Once the password is entered, press OK. (Factory setting:1111)
6Press the Setup tab > Network Setup.
7Select TCP/IP Protocol.
8Press IP Setting.
3.2 <Getting Started>
