Sanyo DSR-3709, DSR-3716 Connecting Sensor Alarm OUT terminals, Connecting Control terminals

3INSTALLATION AND CONNECTIONS

Connecting SENSOR ALARM OUT terminals

The SENSOR ALARM OUT terminals are used to relay alarm signals whenever one of the digital video recorder’s motion sensors is triggered. Normally in an open condition, a terminal adopts low condition when a sensor for the corresponding camera number has been triggered.

1K	Rating for each terminal
	z Maximum current: 25 mA
	z Maximum voltage: 25 V

Connecting CONTROL terminals

The connections for a remote control circuit are shown below. This digital video recorder can be remotely controlled when a remote-control circuit similar to that shown here is connected to the remote-input control terminals.

C R1 R2

R1 R2

Connecting the power cord

1 When you have finished making all the other connections, make sure the voltage is 120 V-240 V AC and insert the power plug into the wall outlet.

There is no power switch. The display indicators flash, and after a few moments, the monitor screen displays the camera image.

120 V-240 V AC (50/60 Hz)

zWhen turning the power on for the first time “PLEASE SET THE CLOCK” is displayed on the monitor screen. Follow the procedures on P.17 to set the clock.

zIf the clock is already set

The operation display area is displayed.

Operation
	01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
display area

02

INTRODUCTION

(When operated (When combined independently) with R2 Shift key)

SW 1 : Camera 1*: INDEX +

SW 2 : Camera 2*: INDEX -

SW 3 : Camera 3*: AUTO FOCUS

SW 4 : Camera 4*: SEQUENCE

SW 5 : Camera 5*: MON2 SW 6 : Camera 6*: PLUS

SW 7 : Camera 7*: QUAD

SW 8 : Camera 8*: MULTI

SW 9 : Camera 9*: MENU RESET

SW 10 : Camera 10:

SW 11 : Camera 11: PAN left

SW 12 : Camera 12: PAN right

SW 13 : Camera 13: TILT down

SW 14 : Camera 14: TILT up

SW 15 : Camera 15: ZOOM wide SW 16 : Camera 16: ZOOM tele

SW 17 : REC/STOP SW 18 : PLAY/STOP

SW 19 : STILL

SW 20 : SEARCH

SW 21 : SHIFT (Doubles with R1)

SW 22 : PLAY

SW 23 : REC

SW 24 : MENU

SW 25 : EXIT/OSD

SW 26 : +

SW 27 : -

SW 28 : →

SW 29 : ←

SW 30 : ZOOM

SW 31 : COPY

SW 32 : TIMER

zIf the POWER indicator starts flashing;

If a problem occurs during use, the POWER indicator will begin to flash and an explanation will be displayed. In these cases, contact a Sanyo service center.

POWER	Meaning
indicator status
	There is a problem with the hard disk. The
Four flashes per	hard disk must be replaced or initialized.
second	Contact a Sanyo service center to recover
	recorded images.
One flash per	There is a problem with the fan.
second

z The power cord’s ground terminal is not provided for

enhanced safety; rather, it can be used to reduce the

level of interference when the digital video recorder is

connected to analog devices.

If a large amount of noise is generated when the digital

zUse a resistance of 1/10 ohms or more and with a D ranking (Precision within ±0.5%).

zThe remote control cable should be no more than 5 m long.

* The DSR-3709 can operate up to nine cameras (*).

video recorder is connected to analog devices, connect

this terminal to the building’s earth.

14 English