Sanyo DSR-3716 „ To stop motion sensor recording, Cursor moves to Mode, Flashes for the Mode

3RECORD SET

11 Turn the jog dial to set the sensitivity (OFF or 1 through 10), and then turn the shuttle dial clockwise.

The cursor moves to “MODE”.

									A
			CH01	T	-2	LEVEL	:	1		MODE :	A
[Settings] (‹ indicates default setting)
Setting		Description
‹OFF	Motion sensing is not carried out.
1 to10	Motion sensing is carried out. Lower values
	correspond to higher sensitivities.

12 Turn the shuttle dial clockwise.

“A” flashes for the “MODE”.

						A
CH01	T	-2	LEVEL	:	1		MODE :	A

13 Turn the jog dial to select a “MODE”, and then turn the shuttle dial clockwise.

The mode selection is confirmed and the cursor returns to the top left position.

[Settings] (‹ indicates default setting)

Setting	Description
‹A	The motion sensor alarm is triggered when a
	moving object is detected in A.

BThe motion sensor alarm is triggered when a moving object is detected in B.

	The motion sensor alarm is triggered when a
A AND B	moving object is detected by a sensor in both A
	and B.
	By setting A to important points (or suspected
	points of motion) and setting B to non-moving
A AND NB	points, motion can be detected at point A even
	when the overall brightness changes and in other
	situations where motion at both A and B would
	normally be detected.
	The motion sensor alarm is triggered when an
A TO B	object is detected moving from A to B. (within 2
	seconds from A to B)
	The motion sensor alarm is triggered when an
B TO A	object is detected moving from B to A. (within 2
	seconds from B to A)
	A motion sensor alarm is triggered when the
	entire image changes uniformly. In this way,

Csprays and other similar measures can be protected against. (Setting of sensor positions is unnecessary.)

14 Set “LEVEL” and “MODE” for T-2 through T-4 using the same procedure (i.e., steps 8 through 13).

zMotion sensor positions are common for T-1 through T-4, and different settings cannot be made.

zSensitivity levels and modes can be set individually for T-1 through T-4.

15 Turn the shuttle dial counter-clockwise.

Motion sensor settings are confirmed and the <ALARM REC MODE SET> screen is displayed once again.

„To stop motion sensor recording

(1)During recording, display the <ALARM REC MODE SET> screen and turn the shuttle dial clockwise.

(2)The motion sensor screen is displayed. Turn the sensitivity level OFF.

English 83