3RECORDING
POWER indicator
FULL indicator |
CARD |
MENU
RESET
EJECT
[REC/STOP] button
[TIMER] button
Normal recording
Use the following procedure to record the monitored video in the normal recording area.
Recording will not be possible until a time has been set for the digital video recorder. Make sure to set the time. (JP.17)
1 Press the [REC/STOP] button.
The REC/STOP indicator lights up, “REC” appears on- screen (i.e., the recording symbol), and recording starts.
Recording symbol
REC/STOP |
02
zWhen recording for the first time, the default settings are used. For details regarding modification of the picture quality or recording rate, see P.71.
zWhen the space remaining in the normal recording area drops below a preset value, the FULL indicator on the digital video recorder’s front panel starts to flash. If recording is continued beyond this point, the normal recording area will become full, recording will stop, and the FULL indicator will stop flashing and remain lit. In such a case, use the <RECORDING AREA SET> screen to perform “AREA FULL RESET” for the normal recording area, thus allowing recording to start again from the beginning. (JP.67)
zPlayback is possible even while recording. See P.26 for more details.
Ending normal recording
2 Press and hold the [REC/STOP] button for approximately 3 seconds.
“REC” disappears from the operation display and recording ends.
REC/STOP
Timer recording
Use the following procedure to record the monitored video for a preset length of time in the normal recording area. Recording will not be possible until a time has been set for the digital video recorder. Make sure to set the time. (JP.17)
1 Press the [TIMER] button.
The TIMER indicator lights up and the digital video recorder enters timer recording standby mode.
TIMER
02
(1)See P.74 for more details on timer recording settings.
(2)At the time specified for the start of timer recording, the REC/STOP indicator lights up, “REC” appears on- screen (i.e., the recording symbol), and recording starts.
(3)At the time specified for the end of timer recording, the REC/STOP indicator turns off, and recording ends. The [TIMER] button remains lit up.
zWhen the space remaining in the normal recording area drops below a preset value, the FULL indicator on the digital video recorder’s front panel starts to flash. If recording is continued beyond this point, the normal recording area will become full, recording will stop, and the FULL indicator will stop flashing and remain lit. In such a case, use the <RECORDING AREA SET> menu to perform “AREA FULL RESET” for the normal recording area, thus allowing recording to start again from the beginning. (JP.67)
zPlayback is possible even while recording. See P.26 for more details.
Stopping timer recording before completion
2 Press the [TIMER] button.
The TIMER indicator turns off and recording ends.
TIMER
English | 23 |
