
3RECORD SET
Setting the alarm trigger
Use this setting to indicate how alarms are to be detected.
1 Turn the jog dial to select “ALARM TRIGGER”, and then turn the shuttle dial clockwise.
“ALARM” flashes in the “ALARM TRIGGER” field.
<ALARM REC MODE | SET> | ||
ALARM RECORDING |
| : ENABLED | |
PICTURE QUALITY |
| : ENHANCED | |
AUDIO RECORDING |
| : ON | |
ALARM INTERLEAVE | : ONLY | ||
REC RATE: A | 15FPS, |
| DURATION: 20SEC |
: ON | |||
REC RATE: A | 30FPS, |
| DURATION: 1MIN |
=> (00229 ALARMS CAN |
| RECORDED) | |
ALARM TRIGGER |
| : ALARM | |
MOTION SENSOR |
|
|
|
2 Turn the jog dial to select an alarm detection method, and then turn the shuttle dial clockwise.
[Settings] ( indicates default setting)
Setting | Description | |
|
| |
| Alarm recording is performed when an | |
| external alarm is generated (i.e., | |
ALARM | when a switch is attached to the alarm | |
| input terminal on the rear panel, and | |
| the switch is activated). | |
|
| |
| Alarm recording is performed when a | |
SENSOR | motion sensor detects movement. | |
See the section on setting motion | ||
| ||
| sensors for more details. | |
|
| |
ALARM AND | Alarm recording is performed when | |
both the external alarm and a motion | ||
SENSOR | ||
sensor are activated simultaneously. | ||
| ||
|
| |
| Alarm recording is performed when | |
ALARM OR SENSOR | either the external alarm or a motion | |
| sensor is activated. | |
|
|
[Setting conditions]
zWhen sensor selection has been made (i.e., “SENSOR”, “ALARM AND SENSOR”, or “ALARM OR SENSOR”) it will be necessary to set the motion sensors.
zThe digital video recorder supports the coaxial alarm signal from coaxial superimposition cameras. When a coaxial alarm is input, it is treated as an external alarm.
Setting the motion sensors
Use the following procedure to set motion sensor on video from each camera so that alarms can be detected.
(1)
(2)CH01
(3)(4) (5)
(1)Motion sensor setting
Displays changes in response to the sensor condition, and settings are made turning the jog dial.
A or B: Sensor on
(2)Camera number display
Changes when a [CAMERA SELECT] button is pressed. Use this item to select the camera for which motion sensors are to be setup.
(3)Time period
Select an interval as set using “TIME PERIOD” on P.57.
(4)LEVEL
Sets the sensitivity level of the motion sensors. OFF: No motion sensor has been set.
1 to 10: A motion sensor is set. Lower values correspond to higher sensitivity levels and vice versa.
(5)MODE
Sets the detection method for the motion sensors. (JP.83)
zRefer to “NAMES AND FUNCTIONS OF PARTS” for more details regarding operation of the jog dial and shuttle dial. (JP.9)
English | 81 |