Schneider Electric vw3-a58101 manual Introduction, Installing the display module remotely

GP_ATV58_EN.fm Page 62 Mardi, 2. avril 2002 6:09 18

Introduction

The VW3A58101 display module is supplied with ATV58••••M2 and ATV58••••N4 speed controllers.

ATV58••••••Z speed controllers are supplied without a display module. This can be ordered separately.

Installing the display module on the speed controller :

The protective cover should be removed before installing the display module on an ATV58••••••Z speed

controller.

ENGLISH

POWER FAULT

z

POWER z

FAULT

		ESC
FWD		ENT
REV	RUN
		STOP

RESET

The display module must be connected and disconnected with the power off. If the display module is disconnected when control of the speed controller via the display module is enabled, the speed controller locks in fault mode SLF.

Installing the display module remotely :

Use the kit, reference VW3A58103, comprising 1 cable with connectors, the parts required for mounting on an enclosure door and the installation guide.

Signaling on the front panel of the Altivar

Other LEDs, indicating status with communication option cards.

POWER z	Green LED POWER	on : Altivar powered up
FAULT	Red LED FAULT	• on : Altivar faulty
		• flashing : Altivar locked once the "STOP" key has
		been pressed on the display module or after a
		change to the configuration. The motor can then
		only be supplied with power after resetting prior to
		the "forward", "reverse", and "injection stop"
		commands.

62