Schneider Electric vw3-a58101 05 to 2nd acceleration ramp, 05 to 2nd deceleration ramp, To 2 s

ENGLISH

GP_ATV58_EN.fm Page 78 Mardi, 2. avril 2002 6:09 18

Adjust Menu

The following parameters can be accessed once the I/O have been reassigned on the basic product.

Code	Description			Adjustment range	Factory setting
AC2	Accel. 2	-	s	0.05 to 999.9	5 s
	2nd acceleration ramp
dE2	Decel. 2	-	s	0.05 to 999.9	5 s
	2nd deceleration ramp
	These parameters can be accessed if the ramp switching time (parameter Frt) is other than 0 Hz or
	if a logic input is assigned to ramp switching.
IdC	DC Inj.curr -		A	0.10 to 1.36 In (1)	Acc. to controller rating
	DC injection braking current
	This parameter can be accessed if a logic input is assigned to DC injection stopping.
	After 30 seconds the injection current is peak limited to 0.5 Ith if it is set at a higher value
SP2	Preset Sp.2 - Hz			LSP to HSP	10 Hz
	2nd preset speed
SP3	Preset Sp.3 - Hz			LSP to HSP	15 Hz
	3rd preset speed
SP4	Preset Sp.4 - Hz			LSP to HSP	20 Hz
	4th preset speed
SP5	Preset Sp.5 - Hz			LSP to HSP	25 Hz
	5th preset speed
SP6	Preset Sp.6 - Hz			LSP to HSP	30 Hz
	6th preset speed
SP7	Preset Sp.7 - Hz			LSP to HSP	35 Hz
	7th preset speed
JOG	Jog Freq.	- Hz		0 to 10 Hz	10 Hz
	Jog frequency
JGt	JOG Delay	-	s	0 to 2 s	0.5 s
	Anti-BrkLgSeqFlwd delay between two consecutive jog operations
brL	BrReleaseLev- Hz			0 to 10 Hz	0 Hz
	Brake release frequency
Ibr	BrRelease I -		A	0 to 1.36In(1)	0 A
	Brake release current
brt	BrReleasTime-		s	0 to 5 s	0 s
	Brake release time
bEn	BrEngage Lev- Hz			0 to LSP	0 Hz
	Brake engage frequency
bEt	BrEngageTime- Hz			0 to 5 s	0 s
	Brake engage time

(1)In corresponds to the speed controller nominal current indicated in the catalog and on the speed controller identification label for "high torque" applications.

78