Schneider Electric altivar 58 telemecanique Code Description Adjustment range Factory setting

GP_ATV58_EN.fm Page 75 Mardi, 2. avril 2002 6:09 18

Adjust Menu

Code	Description	Adjustment range	Factory setting
SdC	DC stop.curr - A	0.1 to 1.36 In (1)	Acc. to contr. rating

Injection braking current applied after 30 seconds if tdC = Cont.

Check that motor will withstand this curr. without overheating

JPF Jump Freq. - Hz 0 to HSP 0 Hz

Skip frequency : prohibits prolonged operation over a frequency range of +/-2.5 Hz around JPF. This function can be used to prevent a critical speed which causes resonance.

JF2	Jump	Freq.2	- Hz	0 to HSP	0 Hz
	Second skip frequency: Same function as JPF, for a second frequency value
JF3	Jump	Freq.3	- Hz	0 to HSP	0 Hz
	Third skip frequency: Same function as JPF, for a third frequency value
USC	Machine Coef.			0.01 to 100	1

Coefficient applied to parameter rFr (output frequency applied to the motor), the machine speed is displayed via parameter USP

USP = rFr x USC

tLS LSP Time - s 0 to 999.9 0 (no time limit)

Operating time at low speed. After operating at LSP for a given time, the motor is stopped automatically. The motor restarts if the frequency reference is greater than LSP and if a run command is still present.

Caution : value 0 corresponds to an unlimited time

(1)In corresponds to the speed controller nominal current indicated in the catalog and on the speed controller identification label for high torque applications.

75

ENGLISH