Schneider Electric altivar 58 telemecanique, vw3-a58101 manual Drive menu, To 10 Hz, To 100% 20%

GP_ATV58_EN.fm Page 77 Mardi, 2. avril 2002 6:09 18

Adjust Menu

The following parameters can be accessed in the ‘general use’ macro-configuration

Code	Description		Adjustment range	Factory setting
UFr	IR Compens.	- %	0 to 150% or 0 to 800%	100%
	Used to adjust the default value or the measured value during auto-tuning.
	The adjustment range is extended to 800% if the SPC parameter (special motor) is set to “Yes” in
	the drive menu.
SLP	Slip Comp.	- %	0 to 150%	100%
	Used to adjust the slip compensation value fixed by the motor nominal speed.
JOG	Jog Freq.	- Hz	0 to 10 Hz	10 Hz
	Jog frequency
JGt	JOG Delay	- s	0 to 2 s	0.5 s
	Anti-repeat delay between two consecutive jog operations
tL2	Trq.Limit 2	- %	0 to 200% (1)	200%
	Second torque limit level activated by a logic input
The following parameters can be accessed in the ‘variable torque’ macro-configuration
Code	Description		Adjustment range	Factory setting
IdC	DC Inj.curr	- A	0.10 to 1.36 In (2)	Acc. to controller rating
	DC injection braking current.
	After 30 seconds the injection current is peak limited to 0.5 Ith if it is set at a higher value
PFL	U/f Profile	- %	0 to 100%	20%
	Used to adjust the quadratic power supply ratio when the energy saving function has been inhibited

(1)100% corresponds to the nominal torque of a motor with a power rating equal to that associated with the speed controller in high torque applications.

(2)In corresponds to the speed controller nominal current indicated in the catalog and on the speed controller identification label for "high torque" applications.

Parameters in gray boxes appear if an I/O extension card is installed

77

ENGLISH