V1 |
|
Chapter 2 Fitting and
Power Supply
This unit operates on either a battery pack or an AC supply (using the optional
For details of the power supplies which can be used, refer to the documentation supplied with the VTR connected to this unit or the camera adaptor.
Using an Anton Bauer Intelligent Battery System and Ultralight System
Fitting the special battery mount made by Anton Bauer Corporation to this unit allows you to use their Intelligent Battery System and Ultralight System.
For details, consult your Anton Bauer products supplier or Sony dealer.
Battery pack operating times
The following table shows approximate continuous operating times, when operating the camera and 1.5- inch viewfinder at normal temperatures, with a camera adaptor and an
Approximate operating times with
a
Battery pack | With camera | With | With |
| adaptor | 1P | 3P |
110 minutes | 60 minutes | 60 minutes | |
85 minutes | 45 minutes | 50 minutes | |
— | 130 minutes | 140 minutes |
Battery pack charging
Before using a battery pack, charge it as shown in the following table.
Battery pack | Battery charger | Approximate |
|
| charging time |
|
| (normal temperature) |
70 minutes | ||
|
| |
95 minutes | ||
|
| |
160 minutes |
For details of battery charger operation, refer to the instructions provided with the battery charger to be used.
Chapter 2 Fitting and
Connections
Using Battery Packs
Always fully charge a battery pack before using it.
Notes
•Be careful that other metal objects do not come in contact with the metal parts of the battery pack, as this could cause a short.
•Do not leave the battery pack in the camera if it is not going to be used for a long time.
•If the battery pack is recharged after use while still hot, it may not be possible to obtain a full charge.
Fitting a battery pack (NP-1B)
Open the lid of the battery case, insert a
Press and lift | |
| Pack |
Battery case
40 | Chapter 2 Fitting and Connections |
DXC-35WSL/D35WSPL
Battery pack | With camera | With |
| adaptor |
|
95 minutes | 50 minutes | |
70 minutes | 35 minutes | |
– | 105 minutes |
a)Requires the
Battery low indications
When the voltage of the supply to the camera head lowers to or below 11.0 V, the battery voltage indication appears in the viewfinder. At this time, the BATT indicator in the viewfinder flashes when operating with the
If you continue using the camera head, the BATT indicator lights up.
When the battery pack is low, replace it with a fully- charged battery pack.
Camera Adaptor Power Supply
The camera adaptor automatically operates on power supplied to the VTR/CCU/CMA connector from the portable VTR,
Note
Before use, check that the device connected to the VTR/CCU/CMA connector is able to provide the power required by the camera.
If it is not able to provide the necessary power, or when it is necessary to prolong the operating time, use the camera with a separate power supply.
Connections
Chapter 2 Fitting and Connections | 41 |
