1-14

Fitting a VTR

4 Slide the DSR-1/1P and the camera head together in the groove as far as possible.

Chapter 2

 

Fitting

5 Tighten the two screws in the

and

grip connector and the two

Connections

screws in the shoulder pad

 

 

section.

Using the Camcorder Grip

When using the camera head with a VTR as a

camcorder grip and the method for attaching it differ

camcorder, you can replace the camera head’s grip

slightly depending on the type of VTR.

with a camcorder grip (not supplied). The type of

 

Attaching a camcorder grip to the DSR-1/1P

1 If the viewfinder is attached, adjust the viewfinder to the full-forward position.

For details, see “Adjusting the viewfinder position” on page 32.

2 Remove the camera head grip’s three screws, then pull up the grip to remove it.

Screws

Chapter 2 Fitting and Connections

DXC-D35P/D35WSP(CE) V1

DXC-D35/D35WS(UC)

6 Attach the shoulder pad.

3 Remove the VTR connection

 

plate.

 

VTR connection

 

plate

To remove the VTR

To fit a camera adaptor

Reverse the fitting procedure.

Follow the same procedure as when fitting a VTR.

4 Remove the DSR-1/1P’s shoulder strap fitting and the camera head connection plate.

Camera head connection plate

Shoulder strap fitting

(continued)

26

Chapter 2 Fitting and Connections

Chapter 2 Fitting and Connections

27

Page 22
Image 22
Sony DXC-D35 service manual Fitting a VTR, Using the Camcorder Grip, Attaching a camcorder grip to the DSR-1/1P