Sony DXC-D35 service manual Replacement of CCD Unit, Description on CCD Block Number

2-3. Replacement of CCD Unit

Description on CCD Block Number

Every CCD unit has its own ID number called CCD block number. It shown the CCD block type and serial number for the CCD block.

The CCD block number label is put in the CCD unit.

GUA xxxxx : DXC-D35 (NTSC)

GVA xxxxx : DXC-D35P (PAL)

HDA xxxxx : DXC-D35WS (NTSC)

HEA xxxxx : DXC-D35WSP (PAL)

Serial number for the CCD unit CCD block type

1.Remove the lens and viewfinder. (Refer to the instruc- tion manual.)

n

To protect the prism block, be sure to cover the lens mount portion with the mount cap.

2.Remove the left side plate. (Refer to Section 2-2-1.)

3.Remove the AT board. (Refer to Section 2-2-2.)

4.Disconnect the harness connectors from the four connectors (CN2, CN105, CN106 and CN107) and the flexible card wire from the connector (CN103) on the MB board.

n

When disconnecting the flexible card wire, refer to Section 2-11.

	CN2
	CN105
	CN106
MB board	CN107
	CN123

CN103

DXC-D35/D35WS(UC)

2-3. Replacement of CCD Unit

5.Remove the four screws to remove the front unit assembly.

Front unit assembly

Screws

with washer

(B3 x10)

Screws

with washer

(B3 x10)

6.Remove the setscrew shown in the figure and take off the filter knob.

7.Remove the four screws and four washers of the front panel to remove the CCD unit.

n

Use great care to avoid any pressure on the PA board when handling the CCD unit.

	CCD unit
	Front panel
Washer (SW3)
Screw (B3 x8)
	Setscrew (3 x4)
Screws (B3 x8)	Washers (SW3)
	Filter knob
	2-5

DXC-D35P/D35WSP(CE) V1