Viewfinder Basic Menu
V1 |
Item
MARKER
Sets MARKER display ON/OFF.
DUR TIME
Sets the recording time Setting the recoriding time before shooting helps you with making scenes of equal duration.
When shooting with displaying the recording time of the current cut in the viewfinder (with the REC TIME switch set to DUR), the recording time indication flashes to remind you that the recording time has passed.
Settings
ON (normal value), OFF MARKER is displayed when this setting is ON and is not displayed when it is OFF.
When the setting is ON, go to Advanced Menu 4 to select the type of marker (see page 65).
00:00 to 59:59 (minute to second)
See “Setting the recording time in seconds” below.
Basic menu page 6
The following display is shown when the DSR-1/1P is connected.
ItemSettings
MARK/CUE | MARK (normal value), CUE |
Selects MARK See “Using the ClipLink Function” mode or CUE mode (page 46).
CHG REEL NO See “To set the cassette name/ Sets the cassette number” below.
3 Press the MENU/STATUS switch to move the text entry arrow.
Press the MENU/STATUS switch upward to move the cursor to the right or downward to move it to the left.
The character cycles through the following sequence.
ABCDEFGHIJKLMNOPQRSTUVWXYZ?;x/0123456789:
(Space)
4 Press the UP/ON button or DOWN/OFF button to enter the desired characters.
The displayed character changes each time the UP/ ON button is pressed. It changes in reverse order each time the DOWN/OFF button is pressed.
5 Return to step 2 and repeat the text entry procedure.
Basic menu pages 7 and 8
You can create a title of up to four lines, each of twelve alphanumeric or punctuation characters, and then save it. It is then possible to record the title over the picture while shooting.
Entering the title (page 7)
1 Press the MENU/STATUS switch as necessary to display basic menu page 7 (title setting display) in the viewfinder.
Setting the recording time in seconds
Move the cursor to DUR TIME, then press the UP/ON button or DOWN/OFF button.
A value of seconds is displayed under “SS”.
Chapter 4 Viewfinder Screen Indications and Menus
name/number
To set the cassette name/number (when using
1 Connect the DSR-1/1P and load a cassette.
2 Press the MENU/STATUS switch to move the cursor to CHG REEL NO, then press the UP/ON button.
The cursor (→) changes to the text entry arrow (↓) and the current cassette name/number is displayed. (“NO TAPE” is displayed if you neglected to load a cassette.)
Current cassette name/number
6 After completing text entry, move the text entry cursor to the parenthesis position.
The display changes as follows.
7 Check your cassette name/number setting, and press the UP/ON button if no more changes are required. (To make changes or to abort the procedure for this setting, return to step 2.)
This writes the new cassette name/number to the cassette memory, after which the display changes as follows.
If a title is already present, it appears on this screen. To delete the displayed title, press the UP/ ON and DOWN/OFF buttons simultaneously.
2 Press the UP/ON button.
This brings up the cursor on the screen (flashing), and switches to title editing mode.
Initial cursor position
3 Press the DOWN/OFF button to move the cursor to the position where you wish to insert a character.
To move the cursor back
With the DOWN/OFF button held down, press the UP/ON button.
(continued)
Chapter 4 Viewfinder Screen Indications and Menus
60 Chapter 4 Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus 61
