Viewfinder Basic Menu
4 Press the UP/ON button to select the required character.
Each time you press the UP/ON button, the character cycles through the following sequence.
ABCDEFGHIJKLMNOPQRSTUVWXYZ?;x/0123456789:
(Space)
To reverse the character sequence
With the UP/ON button held down, press the
DOWN/OFF button.
5 Press the DOWN/OFF button to confirm the character selection.
The cursor advances to the next character position.
To change a character after confirming it
Return to step 3, and input the character again.
6 Repeat steps 4 and 5 until the title is complete.
Chapter 4 | 7 | normal viewfinder indications. |
Viewfinder | ||
| When the title is complete, press the MENU/ | |
Screen |
| STATUS switch as necessary to return to the |
| the camera off. | |
Indicationsand |
| The title created is retained, even when you power |
1 Press the MENU/STATUS switch as necessary to | ||
| To record a title (page 8) | |
Menus |
| access basic menu page 8 (title display). |
|
| |
DXC- | |
D35P/D35WSP(CE)V1 | |
| 62 Chapter 4 Viewfinder Screen Indications and Menus |
2 Press the UP/ON button once.
The title is superimposed to the picture displayed on the viewfinder screen.
3 Start shooting.
4 To stop the title recording, press the MENU/ STATUS switch to clear the title display.
Note on using the
When the
When “CHECK DIAG” is displayed
The “CHECK DIAG” indication appears in the status display area whenever the camcorder’s automatic self diagnostic function detects an abnormality. Access this page and perform error checking. (This page is displayed as basic menu page 1.)
“CHECK DIAG” will also be displayed if there is a problem on the sync signal input to the GEN LOCK IN connector. Input a proper sync signal and then perform error checking.
To perform error checking
Press the UP/ON button.
The error checking performs on the digital signal processing (DSP) and memory circuits and the results are displayed.
When no error is detected, “OK” appears.
Example: If an abnormality is detected in the DSP circuit.
DIAGNOSIS
DSP : ERROR
MEMORY: OK
DIAG ERROR
The error message “DIAG ERROR” appears when the normal indications are displayed. If this message appears, contact your Sony dealer.
Chapter 4 Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus 63
