
White Balance Adjustment
Black Balance Adjustment
If the ATW function does not operate correctly A warning massage appears in the viewfinder as
shown in the table below.
Message | Meaning and corrections to be made |
:C.TEMP.LOW | If the FILTER control is in position 2, 3 or |
| 4, change it to position 1, then retry the |
| ATW operation. |
:C.TEMP.HIGH | If the FILTER control is in position 1, |
| change it to position 2, 3 or 4, then retry |
| the ATW operation. |
Chapter 5 Adjustments and Settings
Correct adjustment of the black balance is important for optimum operation of a video camera. It is necessary when using the camera for the first time or after a significant period out of use, and also when there has been a sudden change in temperature.
The adjustment value is saved in memory, and readjustment is not normally necessary after powering the camera off or simply when lighting conditions change.
1 2
1 Move the POWER switch to the ON SAVE position, and check that the OUTPUT/DL/DCC+ switch is in one of the CAM positions.
2 Push the WHT/BLK switch in the BLK direction and release.
The lens iris closes, and black balance adjustment is carried out.
During the adjustment the legend “AUTO BLACK
AUTO BLACK
Note
When using a camera control unit or remote control unit, if the W/B BALANCE switch of the control unit is set to MANUAL, it is not possible to carry out black balance adjustment on the camera.
If black balance adjustment cannot be completed automatically
The warning message “AUTO BLACK
Make the necessary corrections, then carry out the process again.
Warning messages for black balance adjustment
Message | Meaning and corrections to be made | ||
AUTO BLACK | The lens iris did not close fully. | ||
| Check whether the lens cable is | ||
: | IRIS | connected properly, and whether there is | |
NOT CLOSED | a fault in the lens. If a second attempt to | ||
carry out the adjustment fails, consult | |||
| TRY AGAIN | ||
| your Sony dealer. | ||
|
| ||
AUTO BLACK | The iris opened during adjustment or | ||
| there is a hardware error. | ||
: | ?? | Close the iris and try again. If this fails, | |
| TRY AGAIN | consult your Sony dealer. | |
| BARS | The camera is outputting a color bar | |
|
| signal. | |
|
| Move the OUTPUT/DL/DCC+ switch to | |
|
| one of the CAM positions. |
Chapter 5 Adjustments and Settings
DXC- |
| |
D35P/D35WSP(CE)V1 | Chapter 5 Adjustments and Settings | |
| 82 |
After a few seconds the adjustment is complete, and the legend in the viewfinder changes to “AUTO BLACK
Chapter 5 Adjustments and Settings | 83 |