Teledyne API Model 100AH SO2 Analyzer Instruction Manual, 02417, Rev. D

Table 4-2: Front Panel Status LED's

LED

State

Meaning

Green

Off

NOT monitoring, DAS disabled or inactive

 

On

Monitoring normally, taking DAS data

 

Blinking

Monitoring, DAS in HOLDOFF mode (1)

 

 

 

Yellow

Off

Autocal disabled

 

On

Autocal enabled

 

Blinking

Calibrating

 

 

 

Red

Off

No warnings exist

 

Blinking

Warnings exist

 

 

 

(1) This occurs and means during Calibration, DAS holdoff, Power-up Holdoff, and when in Diagnostic mode.

4.2.5.3 Power Switch

The power switch has two functions. The rocker switch controls overall power to the instrument; in addition it includes a circuit breaker. If attempts to power up the M100AH result in a circuit breaker trip, the switch automatically returns to the off position, and the instrument will not power up. If this occurs, consult troubleshooting section or factory.

4.2.6 Power Supply Module

The Power supply module (PSM) supplies AC and DC power to the rest of the instrument. It consists of a 4 output linear DC power supply and a 15 volt switching supply. In addition, it contains the switching circuitry to drive the DC operated valves and several switched AC loads to operate the reaction cell and UV lamp.

4.2.7 Pneumatic System

In the basic analyzer, the sample enters through a 5-micron TFE filter element. The sample then enters the flow control module and the reaction cell. The external pump pack is supplied as standard equipment with the M100AH.

When the zero/span valve option is included, the sample passes through the valve manifold and then enters the reaction cell. (See Section 6.)

Sample flow is controlled by a critical flow orifice. The orifice is protected by a 20-micron filter. The orifice never needs adjustment. The critical flow orifice maintains precise volumetric flow control as long as the down stream pressure of the orifice is maintained under critical pressure. For example, at or near 14" (350 mm) Hg absolute at sea level.

4-7

Page 37
Image 37
Teledyne 100AH Power Supply Module, Pneumatic System, Front Panel Status LEDs, Power Switch, State Meaning