Teledyne 100AH instruction manual Maintenance, 10-1

Teledyne API Model 100AH SO2 Analyzer Instruction Manual, 02417, Rev. D

9 MAINTENANCE		9-1
9.1	MAINTENANCE SCHEDULE	9-1
9.2	REPLACING THE SAMPLE PARTICULATE FILTER	9-2
9.3	REPLACING THE PUMP SCRUBBER	9-4
9.4 CLEANING ORIFICE AND ORIFICE FILTER		9-4
9.5	CLEANING THE REACTION CELL	9-5
9.6	PNEUMATIC LINE INSPECTION	9-5
9.7	LEAK CHECK PROCEDURE	9-8
9.8	LIGHT LEAK CHECK PROCEDURE	9-9
9.9 EPROM REPLACEMENT PROCEDURE		9-10

10 DIAGNOSTIC, TROUBLESHOOTING	10-1
10.1 OPERATION VERIFICATION - M100AH DIAGNOSTIC TECHNIQUES	10-3
10.1.1 Fault Diagnosis with TEST Variables	10-3
10.1.2 Fault Diagnosis with WARNING Messages	10-9
10.1.3 Fault Diagnosis using DIAGNOSTIC Mode	10-11
10.1.4 M100AH Internal Variables	10-18
10.1.5 Test Channel Analog Output	10-20
10.1.6 Factory Calibration Procedure (Quick Cal)	10-21
10.2 PERFORMANCE PROBLEMS	10-23
10.2.1 AC Power Check	10-23
10.2.2 Flow Check	10-24
10.2.3 No Response to Sample Gas	10-24
10.2.4 Negative Concentration Display	10-25
10.2.5 Excessive Noise	10-25
10.2.6 Unstable Span	10-26
10.2.7 Unstable Zero	10-26
10.2.8 Inability to Span	10-27
10.2.9 Inability to Zero	10-27
10.2.10 Non-Linear Response	10-28
10.2.11 Slow Response	10-28
10.2.12 Analog Output Doesn't Agree with Display Concentration	10-28
10.3 ELECTRONIC SUBSYSTEM TROUBLESHOOTING AND ADJUSTMENTS	10-29
10.3.1 Computer, Display, Keyboard	10-29
10.3.2 Voltage/Frequency (V/F) Board	10-33
10.3.3 Status/Temp Board	10-38
10.3.4 Power Supply Module	10-41
10.3.5 Flow/Pressure Sensor	10-45
10.3.6 Reaction Cell Temp	10-49
10.3.7 Preamp Board	10-49
10.3.8 PMT Cooler	10-50
10.3.9 HVPS (High Voltage Power Supply)	10-52

v