Teledyne 100AH instruction manual RS-232 Command Summary, Commands Definition

Teledyne API Model 100AH SO2 Analyzer Instruction Manual, 02417, Rev. D

Table 7-5: RS-232 Command Summary

Commands	Definition
?	Print help screen
T SET ALL	Enable display of all test variables during T LIST
T SET name	Display only NAME during T LIST
T LIST [ALL]	Print all test variables enabled with T SET or ALL
	warnings
T name	Print single test, "name" from Table 7-7
T CLEAR ALL	Disable T LIST, use with T SET name
W SET ALL	Enable display of all warnings during W LIST
W LIST [ALL]	Print warnings enabled with W SET or ALL warnings
W name	Print individual "name" warning from Table 7-8
W CLEAR ALL	Disable W LIST, use with W SET
C command	Execute calibration "command" from Table 7-10
D LIST	Prints all I/O signal values
D name	Prints single I/O signal value/state
D name=value	Sets variable to new "value"
D LIST NAMES	Lists diagnostic test names
D ENTER name	Enters and starts 'name' diagnostic test
D EXIT	Exits diagnostic mode
D RESET	Resets analyzer (same as power-on)
D RESET RAM	System reset, plus erases RAM. Initializes DAS, SO2
	concentration readings, calibration not affected.
D RESET EEPROM	System reset, plus erases EEPROM (RAM_RESET
	actions + setup variables, calibration to default values)
V LIST	Print all easy variable names from Table 10-5
V name	Print individual "name" variable
V name=value	Sets variable to new "value"
V CONFIG	Print analyzer configuration

7-6