Teledyne 100AH instruction manual Optional Hardware and Software

Teledyne API Model 100AH SO2 Analyzer Instruction Manual, 02417, Rev. D

5.2 SAMPLE MODE	5-7
5.2.1 Test Functions	5-7
5.2.2 CAL, CALS, CALZ, Calibration Functions	5-10
5.3 SET-UPMODE	5-12
5.3.1 Configuration Information (CFG)	5-12
5.3.2 Automatic Calibration (AutoCal)	5-12
5.3.3 Data Acquisition System (DAS)	5-12
5.3.4 Range Menu	5-15
5.3.5 Password Enable	5-18
5.3.6 Time of Day Clock	5-18
5.3.7 Diagnostic Mode	5-18
5.3.8 Communications Menu	5-18
5.3.9 Variables Menu (VARS)	5-19

6 OPTIONAL HARDWARE AND SOFTWARE		6-1
6.1 RACK MOUNT OPTIONS		6-1
6.2	ZERO/SPAN VALVES	6-1
6.3	AUTOCAL - SETUP ZERO/SPAN VALVES	6-2
6.4	4-20MA, ISOLATED CURRENT LOOP OUTPUT	6-6

7 RS-232 INTERFACE	7-1
7.1 SETTING UP THE RS-232 INTERFACE	7-1
7.1.1 Setup from the Front Panel	7-1
7.1.2 Security Feature	7-2
7.1.3 Protocol of Port Communication	7-3
7.1.4 Entering Commands in Terminal Mode	7-4
7.2 COMMAND SUMMARY	7-5
7.3 TEST COMMANDS AND MESSAGES	7-8
7.4 WARNING COMMANDS AND MESSAGES	7-9
7.5 CALIBRATION COMMANDS AND MESSAGES	7-11
7.6 DIAGNOSTIC COMMANDS AND MESSAGES	7-13
7.7 DAS COMMANDS AND REPORTS	7-14
7.8 VARIABLES COMMANDS AND MESSAGES	7-16

8 CALIBRATION AND ZERO/SPAN CHECKS		8-1
8.1 MANUAL ZERO/SPAN CHECK OR CALIBRATION THROUGH THE SAMPLE PORT		8-3
8.2	MANUAL ZERO/SPAN CHECK OR CALIBRATION WITH ZERO/SPAN VALVES OPTION	8-5
8.3	AUTOMATIC ZERO/SPAN CHECK	8-6
8.4	DYNAMIC ZERO/SPAN CALIBRATION	8-6
8.5	USE OF ZERO/SPAN VALVES WITH REMOTE CONTACT CLOSURE	8-6
8.6	SPECIAL CALIBRATION REQUIREMENTS FOR DUAL RANGE OR AUTO RANGE	8-7
8.7	CALIBRATION QUALITY	8-8
8.8	CALIBRATION GASES	8-9

iv