Toshiba RAV-SM562BT-E ‡ Drain pan 1. Detachment, Attachment, No. Part name, Procedure, Remarks

No. Part name Procedure Remarks

‡Drain pan 1. Detachment

1)Perform works of items 1 of •, 1 of ‚, 1 of ƒ and 1 of „.

2)Remove clamps of the lead wires con-

nected to the following connectors of the control P.C. board.

CN34 : Float switch (3P: Red)
CN68 : Drain pump (3P: Blue)
CN101 : TC sensor (2P: Black)
CN102 : TCJ sensor (2P: Red)	Screws fixing earth lead wires
CN333 : Power supply of fan motor
(5P: White)
CN334 : Position detection of fan motor	Drain cap
(5P: White)
NOTE :
Remove the connector by releasing locking
of the housing.
3) Remove screws fixing earth lead wire in
the electric parts box. (Ø4 × 6, 2 pcs.)
4) Remove indoor/outdoor inter-unit cable
and remote controller cable of the
terminal block.
5) Remove screws fixing the electric parts
box. (Ø4 × 10, 5 pcs.)
6) Remove screws fixing the bell mouth.
(Ø4 × 10, 6 pcs.)	Screws fixing drain pan

7)Remove the drain cap, and drain water accumulated in the drain pan.

NOTE 1 :

When removing the drain cap, be sure to prepare a bucket to catch the drained water.

NOTE 2 :

Thermal insulator is adhered to the drain cap. Be careful not to peel off the insulator. If the insulator has been peeled, adhere it with double-face tape, etc. as before.

8)Remove screws fixing the drain pan. (Ø4 × 8, 4 pcs.)

2.Attachment

1)Fix the parts, drain cap, drain pan, bell mouth, and electric parts box succes- sively to their original positions.

2)Connect connectors, earth lead wire, indoor/outdoor inter-unit cable, and remote controller cable which have been disconnected in the above item 1 as before.

– 124 –