Toshiba RAV-SM803AT-E Photo / Explanatory diagram, Procedure, Cord heater installation work

No.	Photo / Explanatory diagram	Procedure
	Cord heater installation work
2	Drill a hole on the outdoor unit base plate, and fix the cord heater to the outdoor unit base plate using
	P-shape clamp.
	Connect the cord heater cables.
	Using a motor drill, etc., drill Ø3.2 holes on the outdoor unit base plate.
2-1 See APPENDIX-1 and 2 for the additional hole positions.

These holes are used to fix the cord heater to the outdoor unit base plate with P-shape clamp.

							Insert the PVC tube into the cord heater.
							This tube is designed to protect the cord heater
							from the fixing screws used to secure the
							anchoring feet.
							As shown in the left figure, install the cord
							heater (1.5m) to the outdoor unit base plate by
							using P-shape clamp and screws (Self-tapping
							screw type-B Ø4 × 6mm, stainless).
							Pay attention to the direction of P-shape clamp
			The PVC tube must be inserted
					into the cord heater between		so that it is set to the same direction in the left
				the fixing screws in order to
							figure.
					protect the cord heater from
					these screws.		* If the drain port is frozen due to installation
						Under no circumstances must
							status, etc., draw around the cord heater so
	PVC tube
2-2				the tube be allowed to ride over
							that the end part of the heater is inserted into
			the tip of the fixing screws.
		Ø9.1 P-shape clamp
							the drain port. In this case, add some fixing
							positions to fix the cord heater surely.

* The end part from the marked part of the cord heater heats up. When there is the heating part near the electric parts box, a fire may generate. Be sure to set the heating part on the outdoor unit base plate at the fan room side or near it. (within 20cm from the outdoor unit base plate)

				Enlarged	* Be careful that the cord heater does not hit
					the fan.
Heating part				marked part
					Fix the cord heater without any loosening or
					sag.
					Drill a hole on the side cabinet (R) for fixing the
					thermostat fixing plate.
	Added hole 2-	φ	5

5	Ø5 hole at two positions
46	When drilling a hole on the side cabinet (R), be
	sure not to damage the cabinet.

7

2-3

Side cabinet (R)

– 188 –