Toshiba RAV-SM803UT-E, RAV-SM1102CT-E Part name, Procedure, Remarks, Heat exchanger support

No.	Part name		Procedure	Remarks
ˆ Horizontal		1.	Push the louver holder toward arrow
	louver		direction of right figure, and pull out
			the center shaft (SM562, SM802 :
			1 position, SM1102, SM1402 :
			2 positions) from louver holder.
		2.	Pull off the left and right chaft of
			horizontal louver.
					8 -1
				Louver holder	Shaft of
					horizontal louver
‰ TC, TCJ sensor		1.	Remove the drain pan.
		2.	Remove the set screws (4 positions)	Screws
			and heat exchanger support.	(Fixing heat exchanger support)
		3.	Pull out the sensor is inserted into
			pipe of the heat exchanger.

9 -3

Heat exchanger Heat exchanger support

Š Heat	1.	Take down the main unit and then
exchanger		treat the heat exchanger on the
		floor.
	2.	Remove the drain pan.
	3.	Remove the set screws (6 positions)
		of fixing heat exchanger and main
		unit.

10 -3

Screws

(Fixing heat exchanger and main unit)

– 133 –