Toshiba RAV-SP1102UT-E No. Part name, Procedure, Remarks, Compressor, Discharge pipe

No. Part name	Procedure	Remarks
‡ Compressor	1) Perform works of items 1 of • and	Partition plate
	‚, ƒ, „, ….

2)Discharge refrigerant gas.

3)Remove the partition plate. (ST1T Ø4 × 10L, 2 pcs.)

4)Remove the noise-insulator.

5)Remove the terminal covers of the compressor, and disconnect lead wires of the compressor and the compressor thermo assembly from the terminal.

6)Remove pipes connected to the

	compressor with a burner.		Compressor
			lead
	CAUTION
Pay attention to that flame does not			Case thermo
involve 4-way valve or PMV. (If doing
so, a malfunction may be caused.)
7)	Take off the fixing screws of the
	bottom plate and heat exchanger.		Heat exchanger
	(ST1T Ø4 × 10L, 2 pcs.)	Remove
8)	Take off the fixing screws of the valve
		(Discharge pipe)
	clamping plate to the bottom plate.
9)	Pull upward he refrigerating cycle.	Remove	Screw
10) Take off nut fixing the compressor to
		(Suction pipe)
	the bottom place.		Valve
			support board
	CAUTION		Screws (2 pcs.)
When reconnecting the lead wires to			Compressor bolt (3 pcs.)
the compressor terminals after
replacement of the compressor, be
sure to caulk the Faston terminal
without loosening.

ˆ Reactor	1)	Perform works of item 1 of • and ƒ.		Partition	Reactor
	2)	First take off two screws	Reactor	plate
					support board
		(ST1T Ø4 × 10L) of the reactor fixed
		to the reactor support.
	3)	Remove the reactor support from the
		partition plate.
		(ST1T Ø4 × 10L, 4 pcs.)
	4)	Take off two screws
		(ST1T Ø4 × 10L) directly attached to
		the partition plate.

– 139 –