Toshiba RAV-SM562CT-E No. Part name, Procedure, Remarks, Screws fixing earth lead wires

No. Part name Procedure Remarks

†Fan motor 1. Detachment

1)Perform works of items 1 of • and 1 of

‚.		Screws fixing electric parts box
2) Remove clamps of the lead wires
connected to the following connectors of
the control P.C. board.
CN33	: Louver motor (5P: White)
CN34	: Float switch (3P: Red)
CN68	: Drain pump (3P: Blue)
CN101	: TC sensor (2P: Black)	Screws fixing earth lead wires
CN102 : TCJ sensor (2P: Red)
CN333 : Power supply of fan motor		Bell mouth
	(5P: White)
CN334 : Position detection of fan motor
	(5P: White)

NOTE :

Remove the connector by releasing locking of the housing.

3)Remove screws fixing earth lead wire in the electric parts box. (Ø4 × 6, 2 pcs.)

4)Remove indoor/outdoor inter-unit cable

and remote controller cable of the	Turbo fan
terminal block.

5)Remove screws fixing the electric parts box. (Ø4 × 10, 5 pcs.)

6)Remove screws fixing the bell mouth. (Ø4 × 10, 6 pcs.)

7)Remove nuts fixing the turbo fan. (M6, 1 pc.)

8)Remove screws fixing holder of the motor lead wires to remove the motor lead wires from the clamp. (Ø4 × 8, 3

pcs.)	Motor lead holder
9) Remove nuts fixing the fan motor to
remove it.

2.Attachment

1)Fix the parts, fan motor, holder of the motor lead, turbo fan, bell mouth, and electric parts box successively to their original positions.

NOTE 1 :
When fixing the turbo fan, be sure to match	Fan motor
the fan boss with D-cut of the motor shaft.
NOTE 2 :

Fix the turbo fan with torque wrench

5.9± 0.6Nm.

2)Connect connectors, earth lead wire, indoor/outdoor inter-unit cable, and remote controller cable which have been disconnected in the above item 1 as before.

– 123 –