Toshiba RAV-SM803AT-E, RAV-SM1102CT-E, RAV-SM1102BT-E No. Part name, Procedure, Remarks

No. Part name		Procedure	Remarks
… Drain pan	1.	Take down the main unit and then treat	Screws
		the drain pan on the floor.
			(Fixing lower plate and main unit)
	2.	Remove the both side panels and
		suction grilles.
	3.	(SM802, SM1102, SM1402CT-E only)
		Remove the set screw (1 position) to
		fixing and reinforcing bar.
		(Slide the reinforcing bar toward arrow
		side on the right figure.)	5	-4
	4.	Remove the set screws (9 positions) of	Heat insulation
		fixing lower plate.
	5.	Remove the heat insulation on the	The screw that fixed drain pan and
			main unit is under this insulation.
		drain pan.
		(SM562, SM802 : 1 position, SM1102,
		SM1402 : 2 positions)
	6.	Remove the set screws
		(SM562, SM802 : 1 position, SM1102,
		SM1402 : 2 positions) of fixing drain
		pan and main unit.
	7.	Remove the drain pan.	5	-5
		Pull it lower side.	5	-6
† Vertical grille	1.	Remove the drain pan.	Vertical grille
	2.	Remove the set screws (2 positions) of
		fixing vertical grille.
	3.	Remove the vertical grille.

Screws

(Fixing drain pan and vertical grille) 6 -2

‡ Louver motor,	1.	Remove the side cover (right side only).
Lover drive	2.	Remove the set screws (2 positions)	Screws
member		and louver motor.	(Fixing louver drive member and main unit)
	3.	Remove the set screws (2 positions)
		and louver drive member.
			Louver drive
			member
			Louver
			motor
			7 -3
			Screws
			(Fixing louver motor and louver drive member)

– 132 –