Toshiba RAV-SM803UT-E, RAV-SM1102CT-E, RAV-SM1102BT-E No. Part name, Procedure, Remarks, support

No. Part name	Procedure	Remarks
ˆ Compressor 1)	Perform works of items •, ‚, ƒ, and „.
2)	Evacuate refrigerant gas.	Motor
3)	Disconnect the connector for fan motor from	base
	the inverter.

4)Take off screws fixing the motor base to the bottom plate. (ST1T Ø4 × 10L, 2 pcs.)

5)Remove the motor base together with the fan motor and the propeller fan.

6)Take off screws fixing the partition plate to the valve support plate.

(ST1T Ø4 × 10L, 2 pcs.)	Partition plate
7) Remove the valve support plate.
(M6 × 4 pcs.)

8) Take off screws of the partition plate and the bottom plate. (ST1T Ø4 × 10L, 2 pcs.)

9) Take off screws of the partition plate and the heat exchanger. (ST1T Ø4 × 10L, 2 pcs.)

10)	Remove the noise-insulator.	Screw	Valve support
11)	Remove the terminal covers of the com-
	pressor, and disconnect lead wires of the
	compressor and the compressor thermo
	assembly from the terminal.
12)	Remove pipes connected to the compres-		Partition
			plate
	sor with a burner.

CAUTION

Pay attention to that flame does not involve 4-way valve or PMV.

(If doing so, a malfunction may be caused.)

13) Pull the refrigerating cycle upward.	Valve
	support

14)Take off nut fixing the compressor on the bottom plate. (3 pcs.)

15)Pull the compressor toward you.

CAUTION
When reconnecting the lead wires to the	Compressor
compressor terminals after replacement of
	lead wire
the compressor, be sure to caulk the Faston
terminal without loosening.	Case thermo

Remove (Discharge

Removepipe) (Suction

pipe)

Compressor

nut (3 pcs.)

– 147 –