Toshiba RAV-SM1402CT-E Requirement, Part name, Procedure, Remarks, Inverter assembly

No.	Part name		Procedure		Remarks
„ Inverter		1) Perform works of items of 1) to 5) of •.
	assembly	2) Take off screw (ST1T Ø4 × 10L, 1 pc.) of			Screw
		the upper left part of the inverter cover.
		•	If removing the inverter cover under this		Inverter
			condition, P.C. board can be checked.		assembly
		•	If there is no space in the upper part of
			the upper cabinet, perform works of		Holder
			items 6) to 7) of (1) and remove the
			partition fixing plate.
			(ST1T Ø4 × 10L, 1 pc.)
			CAUTION
		Be careful to check the inverter because			Inverter
		high-voltage circuit is incorporated in it.			cover
		3) Perform discharging by connecting the
		discharging resistance (approx. 100Ω		,	Inverter
		40W) or plug of soldering iron to + ,		–	assembly
		terminals of the C10 too 13 (printed as
		“CAUTION HIGH VOLTAGE”) electrolytic
		capacitor (760µF) of P.C. board.
			WARNING		Plug of
					soldering iron
		The electrolytic capacitor may not nor-			Left time:
		mally discharge according to error con-
		tents and the voltage may remain. There-			10 sec. or more
		fore, be sure to discharge the capacitor.
			WARNING
		For discharging, never use a screwdriver			Inverter assembly
		and others for short-circuiting between		+
		and – electrodes.
		As the electrolytic capacitor is one with a
		large capacity, it is very dangerous
		because a large electric spark will occur.

4)Remove various lead wires from the holder at upper part of the inverter box.

5)Remove the hook for the partition plate

(lower left side).
6) Remove the hook for the side cabinet	Hook for the side
(lower left side) and the screw, and lift up	cabinet (lower left side)	Screw
the inverter assembly upward. (ST1T Ø4

×10L, 1 pc.) In this time, cut off the band bundling each lead wire.

REQUIREMENT
As each connector has a lock mechanism,	Remove the connectors
avoid to remove the connector by holding	with locking function by
	pushing the part indicated
the lead wire, but by holding the connector.	by the arrow mark.

– 143 –