4 Replacement Procedure | 4.29 Fluorescent Lamp |
Fixing the PCB and bezel
1.Fixing the PCB and bezel with four screws at the right side and left side (four points) as shown in the following figure.
CAUTION: 1. The tightening torque must be 0.167 N m (1.7kgf･cm) for all the screws. There shall not be screw floating.
2. Use an insert bit of point size 0 for the Philips screwdrivers.
Attaching tapes and insulation sheet
1. Attach the
CAUTION: When attaching tape and insulation sheet, be careful not to damage the PCB, cell and B/L.
Insulation sheet with
Insulation sheet with
Tape on the side of bezel
Insulation sheet
Insulation sheet with
CAUTION Label
Serial Label
Disposal Label
Figure 4-58 Replacing TMD fluorescent lamp (10)
[CONFIDENTIAL] | PORTÉGÉ M500 Maintenance Manual |
