4.21 Fan/CPU

4 Replacement Procedures

4.21 Fan/CPU

Removing the Fan/CPU

To remove the fan/CPU, follow the steps below and refer to Figure 4-31 to 4-33.

CAUTION: 1) The CPU can become very hot during operation. Be sure to let it cool before starting repair work.

2)When you remove the heat sink, wipe the grease off of the bottom of the heat sink and top of the CPU. Apply new grease when installing.

1.Remove the glass tape on the back of the system board and disconnect the fan cable from the connector CN8771 on the system board.

2.Remove the following screws securing the CPU holder in the opposite order of the marks (number) on the holder and remove the CPU holder.

• M2⋅4B BIND screw

⋅3

M24B BIND

CPU holder

Glass tape

Fan cable

CN8781

Figure 4-31 Removing the CPU holder

PORTÉGÉ M500 Maintenance Manual (960-559)

[CONFIDENTIAL]

4-53

Page 283
Image 283
Toshiba SATELLITE U200 manual 21 Fan/CPU Replacement Procedures, Removing the Fan/CPU