Toshiba SATELLITE U200 manual Installing the LCD unit / FL inverter

4 Replacement Procedures 4.23 LCD unit/FL inverter

Installing the LCD unit / FL inverter

To install the LCD unit / FL inverter, follow the steps below and refer to Figure 4-38 to 4-42.

1. Set two LCD supports to the LCD and secure them with the following screws.

• M2⋅3S S-THIN HEAD screw ⋅4

CAUTION: When installing the LCD support, do not mistake the left for the right and vice versa. “L” for the left, “R” for the right and “UP” for the up of the bracket are marked on the bracket.

2.Stand the LCD unit on the display cover and connect the LCD cable to the connector on the back of the LCD unit. Stick two glass tapes on the connector of the LCD.

3.Install the LCD unit to the display cover.

4.Connect two cables to the FL inverter.

5.Install the FL inverter in place while sticking the double-sided tape.

6.Insert the insulator under the LCD unit.

7.Install the LCD mask (with double-sided tape) while hooking the latches.

8.Secure the LCD mask with the following screws.

• M2.5⋅6B FLAT HEAD screw ⋅4

9.Stick the mask seals (2 points) and mask rubbers (2 points).

10.Install the display assembly to the base assembly and secure it with the following screws.

• M2.5⋅4B FLAT HEAD screw ⋅3

4-64 [CONFIDENTIAL] PORTÉGÉ M500 Maintenance Manual (960-559)