Maintenance

Procedure 4: Removing the Power Supply

To remove the power supply from the mainframe you must first remove the fan assembly. Perform Procedure 2 on page 8±6, to remove the fan assembly then continue with the following steps:

1.Using the handle on the power supply, firmly pull out the power supply from the rear of the mainframe.

2.Remove two 3/32 hex-drive screws and washers to remove the handle from the power supply.

Mainframe

Power supply

Procedure 5: Removing the Card Guides

Handle

Figure 8±9: Removing the power supply

The card guides at the top and bottom of the mainframe are very similar. The main difference is that the bottom guides (IntelliGuides) include the spring- loaded shutters to redirect air into the mainframe. The procedure for removing both guides is identical. Refer to Figure 8±10 while performing the following steps:

1.Use a small flat blade screw driver to pry up the tab of the card guide at the front of the mainframe, being careful not to damage the card guide or the mainframe.

2.Gently pull the card guide forward until it pops out of place.

3.Remove the card guide.

8±12

VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual