Appendix B: Special Configuration Options
Front Panel SYSReset Cable Connector Configuration
The IntelliFrame Mainframe front panel switch cable connector must be configured as shown in Figure B±2 before the SYSReset feature can be utilized. Perform the following procedures to activate the SYSReset feature:
1.Remove the mainframe cover.
2.Cut the tie wrap that secures the SYSReset connector to the front panel switch cable.
3.Connect the SYSReset connector to J29 on the backplane circuit board.
4.Replace the mainframe cover.
Cut tie warp
SYSReset connector
J29
Figure B±2: SYSReset cable connector
VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual | B±3 |