Getting Started

Install the Rackmount Kit Hardware

HT-20 Torx driver

H#2 Phillips screwdriver

Refer to Figure 1±6 and perform the following steps to install the rackmount kit hardware:

1.Determine where you want the mainframe positioned in the rack (recessed inside the rack or protruding in front of the rack).

If you want the mainframe installed protruding in front of the rack, position the rackmount bracket as shown on the right side of Figure 1±6. If you want to recess the mainframe in the rack, position the rackmount bracket as shown on the left side of Figure 1±6.

2.Determine how far you want to recess or extend the IntelliFrame Mainframe and install the rackmount adapter as shown using two 8-32 screws (included with the kit). Repeat this step for the other bracket.

NOTE. To comply with VXIplug&play mounting specifications, position the rackmount adapter at the mounting holes with the adjacent identifier keys (see Figure 1±6). This results in 3.960 in (10.06 cm) from the module panel mounting surface to the rack frame mounting surface.

VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual

1±13