
Maintenance
Procedure 7: Removing
the Temperature Sense
Board
To remove the Temperature Sense board, perform Procedure 1 on page 8±5 to remove the mainframe cover, and then complete the following steps:
1.Disconnect the ribbon cable from the Temperature Sense board.
2.Refer to Figure 8±12 and gently pry up on each retainer holding the Temperature Sense board in place.
3.Tilt the board forward and lift the board out of the holes at the top of the mainframe, being careful not to damage any components on the circuit board.
NOTE. If you replace the Temperature Sense board, you have to calibrate the mainframe. Refer to Adjustment Procedures beginning on page 7±1 for information on calibrating the mainframe.
Temperature sense board
Retainer
Cable
Figure 8±12: Removing the temperature sense board
8±16 | VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual |