
Getting Started
13.Slide the mainframe back until it stops.
14.Push to release the button latches, located on the outside of each track, and continue to slide the mainframe all the way back into the rack cabinet.
15.Tighten the four screws that you left loose at the rear of the rack when you performed step 8, and pull the mainframe part way out of the rack. (Tighten the
16.Be sure that the screws that you left loose at the front of the rack are loose enough to allow the
17.Tighten the screws and push the mainframe all the way into the rack. If the tracks do not slide smoothly, readjust the level using the method described in steps 15 and 16. (Tighten the
18.Install the proper power cord at the rear of the mainframe.
NOTE. To ensure the mainframe is properly mounted in the rack do not tighten the screws while installing the chassis track to the rack front rails. After all the mounting screws have been installed shift the mainframe to the far right of the rack, then tighten all the mounting screws. Refer to Figure 1±10 for screw positions. Depending on the rack manufacturer it may be necessary to use an additional spacer plate, refer to the Replaceable Parts on page 9±15.
| Left rack rail & chassis | Right rack rail & | |
| slide assembly | chassis slide assembly | |
|
| Rack front | |
Rack |
| rail | |
Spacer | Chassis | ||
front rail | |||
Chassis | plate | slide | |
| assemblies | ||
slide |
|
| |
assemblies |
|
|
Shift the mainframe to the far right. Do not tighten the screws until all all screws are touching the left side of the slots.
Figure 1±10: R1 or R2 rackmounting screw positions (front view).
1±18 | VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual |