Chapter 3 Hardware Introduction

3.4 Wall-mounting

See Chapter 1 on page 17 for the ZyWALL models that can be wall-mounted. Do the following to attach your ZyWALL to a wall.

1Screw two screws with 6 mm ~ 8 mm (0.24" ~ 0.31") wide heads into the wall 150 mm apart (see the figure in step 2). Do not screw the screws all the way in to the wall; leave a small gap between the head of the screw and the wall.

The gap must be big enough for the screw heads to slide into the screw slots and the connection cables to run down the back of the ZyWALL.

Note: Make sure the screws are securely fixed to the wall and strong enough to hold the weight of the ZyWALL with the connection cables.

2Use the holes on the bottom of the ZyWALL to hang the ZyWALL on the screws.

3.5Front Panel LEDs

This section introduces the ZyWALL’s front panel LEDs.

 

39

ZyWALL 110/310/1100 Series User’s Guide