ZyXEL Communications 110, 1100, 310 manual 477

Chapter 37 System

Figure 330 Configuration > System > TELNET

The following table describes the labels in this screen.

Table 188 Configuration > System > TELNET

LABEL	DESCRIPTION
Enable	Select the check box to allow or disallow the computer with the IP address that matches
	the IP address(es) in the Service Control table to access the ZyWALL CLI using this
	service.
Server Port	You may change the server port number for a service if needed, however you must use the
	same port number in order to use that service for remote management.
Service Control	This specifies from which computers you can access which ZyWALL zones.
Add	Click this to create a new entry. Select an entry and click Add to create a new entry after
	the selected entry. Refer to Table 185 on page 461 for details on the screen that opens.
Edit	Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove	To remove an entry, select it and click Remove. The ZyWALL confirms you want to remove
	it before doing so. Note that subsequent entries move up by one when you take this action.
Move	To change an entry’s position in the numbered list, select the method and click Move to
	display a field to type a number for where you want to put it and press [ENTER] to move
	the rule to the number that you typed.
#	This the index number of the service control rule.
	The entry with a hyphen (-) instead of a number is the ZyWALL’s (non-configurable)
	default policy. The ZyWALL applies this to traffic that does not match any other configured
	rule. It is not an editable rule. To apply other behavior, configure a rule that traffic will
	match so the ZyWALL will not have to use the default policy.
Zone	This is the zone on the ZyWALL the user is allowed or denied to access.
Address	This is the object name of the IP address(es) with which the computer is allowed or denied
	to access.
Action	This displays whether the computer with the IP address specified above can access the
	ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
Apply	Click Apply to save your changes back to the ZyWALL.
Reset	Click Reset to return the screen to its last-saved settings.

	477
ZyWALL 110/310/1100 Series User’s Guide