ZyXEL Communications 110, 1100, 310 PAP, CHAP, MSCHAP, MSCHAP-V2, Nailed-Up

Chapter 4 Quick Setup Wizards

Figure 27 WAN and ISP Connection Settings: (PPTP Shown)

The following table describes the labels in this screen.

Table 12 WAN and ISP Connection Settings

LABEL	DESCRIPTION
ISP Parameter	This section appears if the interface uses a PPPoE or PPTP Internet connection.
Encapsulation	This displays the type of Internet connection you are configuring.
Authentication	Use the drop-down list box to select an authentication protocol for outgoing calls.
Type	Options are:
	CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by this remote
	node.
	CHAP - Your ZyWALL accepts CHAP only.
	PAP - Your ZyWALL accepts PAP only.
	MSCHAP - Your ZyWALL accepts MSCHAP only.
	MSCHAP-V2- Your ZyWALL accepts MSCHAP-V2 only.
User Name	Type the user name given to you by your ISP. You can use alphanumeric and -_@$./
	characters, and it can be up to 31 characters long.
Password	Type the password associated with the user name above. Use up to 64 ASCII characters
	except the [] and ?. This field can be blank.
Retype to	Type your password again for confirmation.
Confirm
Nailed-Up	Select Nailed-Upif you do not want the connection to time out.
Idle Timeout	Type the time in seconds that elapses before the router automatically disconnects from
	the PPPoE server. 0 means no timeout.
PPTP Configuration	This section only appears if the interface uses a PPPoE or PPTP Internet connection.
Base Interface	This displays the identity of the Ethernet interface you configure to connect with a
	modem or router.
Base IP Address	Type the (static) IP address assigned to you by your ISP.
IP Subnet Mask	Type the subnet mask assigned to you by your ISP (if given).

46
	ZyWALL 110/310/1100 Series User’s Guide