Configuring IPX for Remote Sites Connection 9-3

Modifying or To modify information pertaining to an existing IPX network or to delete Deleting an IPX that information from your configuration, follow these steps:

Network

1Proceed to the IPX screen, following steps from the previous section.

2Select an IPX network you wish to modify or delete.

3Click Modify/Delete.This brings up the IP Modify/Delete screen containing the following fields:

4You may enable or disable the selected IPX network by clicking Modify or Delete.

5Click Modify after you have entered your fields.

If you need to return to the original parameters for this screen, click the Reset button before you click Modify.

Configuring IPX for

To set up a protocol over the WAN, a remote site profile must be created

Remote Sites

and edited for each remote location you want to connect to. With this

Connection

profile, you specify virtual circuit (VPI, VCI) information, protocols, and

 

addresses that determine the method of connection and communication

 

to that remote site.

 

The steps you take to assign a network over the WAN are quite different

 

from those to assign a network over the LAN. First you add a remote site

 

profile, then you modify the profile to include the WAN network

 

information, such as IPX addresses and IPX routing.

Page 103
Image 103
3Com 3C840 manual Configuring IPX for, Remote Sites, Information, such as IPX addresses and IPX routing