3Com 3C840 manual Configuring IP for, Connection, Parameters for, Remote Site

Configuring IP for the Remote Site Connection 4-7

Configuring IP for	To set up connections over the WAN, a remote site profile must be
the Remote Site	created and edited for each remote location you want to connect to.
Connection	With this profile, you specify ATM virtual circuit information, protocols,
	and addresses that determine the method of connection and
	communication to that remote site.
	You first need to add a remote site profile, then modify the profile to
	include WAN connection and network information. The following list
	summarizes the necessary information:
	■ Frame Relay/ATM WAN — Network Service (PPP/RFC 1483/ RFC
	1490) information, ATM VC information
	■ IP — IP addresses, address translation tables, static routes, RIP usage
	■ IPX — IPX network address information, static routes and services, RIP
	usage
	■ Bridging — Enable or disable bridging to the remote site
	If you need to connect to multiple remote sites (i.e., the Internet and a
	remote office) you should set up a remote site profile for each location.
Configuring IP	The following steps illustrate how you configure the IP parameters of the
Parameters for the	remote site profile.
Remote Site	These instructions assume you have already added a remote site profile. If
	you need to add a remote site profile, select Add instead of Modify in
	step 1.

1Access this screen by going to the OfficeConnect Remote 840 home page. Select Configuration > Remote Sites (WAN), and click Modify. This will access the Remote Sites General screen.

2Continue clicking Next to advance through the ATM Modify screen to the IP Modify screen.