UPGRADING OPERATIONAL

10 SOFTWARE FOR THE

OFFICECONNECT REMOTE 840

Introduction

This chapter details the updating of the OfficeConnect Remote 840

 

software. It is divided into the following sections:

 

“Obtaining Updated OfficeConnect Remote 840 Software”

 

“Installing Operational Software to the OfficeConnect Remote 840

 

Unit”

 

 

Obtaining Updated

The OfficeConnect Remote 840 operational software is stored in the

OfficeConnect

unit's FLASH memory. In order to update the operational software, you

Remote 840

must first obtain and copy it to your PC's hard drive. You can then install

Software

it into FLASH memory on the OfficeConnect Remote 840.

 

The method of obtaining the latest versions of the OfficeConnect Remote

 

840 Operational Software is either via the 3Com website,

 

www.3com.com/ocr840 or via the CD. Install the latest version

 

software from the website or the OfficeConnect Remote 840 CD. Type

 

show system, using the CLI interface, to verify the version software

 

installed on your OfficeConnect Remote 840.

 

If you have erased the operational software from your OfficeConnect

 

Remote 840, you will need to reinstall the software using a utility on your

 

CD. Follow the procedure described in “Installing Software via DOS”.

 

Once you obtain the OfficeConnect Remote 840 operational software,

 

there are two methods of installing the software into the FLASH memory.

 

OfficeConnect Remote 840 Manager Software Update (preferred

 

method).

 

DOS Update.

Page 115
Image 115
3Com 3C840 manual Upgrading Operational Software for Officeconnect Remote, Obtaining Updated