3Com 3C840 manual Only, Network Information

E-4APPENDIX E: CONFIGURATION (NON-SETUP WIZARD) OF THE OFFICECONNECT REMOTE 840

Step 2: Configuring

the Remote Site ATM

Parameters (ATM

Only)

Step 3: Configuring

the Remote Site IP

Network Information

The ATM Modify screen is to be filled in with information from the Configuration Planning Forms in Chapter 1 of the Installation Guide.

The screen contains the following fields:

1Enter the information in these fields as contained in the Configuration Planning Forms.

■Enter the Virtual Path Identifier (VPI) and the Virtual Channel Identifier (VCI) for the virtual channel you are configuring.

■If necessary, enter any upstream Category of Service parameters that may have been provided to you.

■The default value of UBR with a Peak Cell Rate (PCR) of 0 will attempt to use all available bandwidth when transmitting.

2Press Next to continue on to the IP Modify Screen.

The IP Modify screen contains the following fields.