Wireless Interface Cards
Installing the NXA-WC80211GCF
1.Grip the sides of the
2.Carefully peel off one side of the included
3.Align the
4.Locate the
FIG. 11 Adhering the antenna plate to the MVP outer housing
5.Grip the antenna by its sides and carefully
6.Align the antenna into the long vertical groove in the cutout and firmly adhere it to the inner surface of the housing.
Make sure the wire is threaded along the left side of the cutout, this helps in the removal of the cutout.
7.With the antenna now securely attached to the MVP’s inner housing, remove the cutout by carefully pulling up on the cutout and threading the antenna wire through the
Closing and Securing the MVP Enclosure
Once the card has been installed, close and
1.Reinstall the dark grey trim along the top rim of the board (A in FIG. 12).
2.While angling the top rim of the MVP’s rear outer housing (B in FIG. 12) down toward the IR Emitters, insert the four outer housing latches into their corresponding attachment locations along the top rim of the MVP panel (two on either side of the IR Emitters).
3.While firmly holding the top rims together, gently press down on the bottom ridge of the outer housing (at the latch locations) and verify that each housing latch fits within its corresponding attachment location on the board. When done, complete the insertion of the remaining housing latches.
4.Verify that the notches along the bottom of the plastic battery slot separator strip also fit into the three provided alignment holes on the circuit board.
5.Firmly press down around the entire rim of the outer housing to snap the cover back into place.
16 |
