AMX MVP-7500/8400 manual These must match

Configuring Communications

14.Select Protected Setup > System Settings (located on the lower-left) to open the System Settings page (FIG. 30).

The System Number is assigned to the Master within the AMX software application

(these must match)

Enter the IP Address information of the PC used as a Virtual Master

When using a Virtual Master, there is no need to enter a username and/or password

FIG. 30 Sample System Settings page (for Virtual Master communication)

15.Press the blue Type field (from the Master Connection section) until the choice cycles to the word Ethernet.

16.Press the Mode field until the choice cycles to the word URL.

By selecting URL, the System Number field becomes read-only (grey) because the panel pulls this value directly from the communicating target Master (virtual or not). A Virtual Master system value can be set within the active AMX software applications such as: NetLinx Studio, TPD4, or IREdit.

17.Press the Master IP/URL field to open a Keyboard and enter the IP Address of the PC used as the Virtual Master.

18.Click Done to accept the new value and return to the System Settings page.

19.Do not alter the Master Port Number value (this is the default value used by NetLinx).

20.Press the Back button to open the Protected Setup page.

21.Press the on-screen Reboot button to both save any changes and restart the panel.

34 MVP-7500/8400 Modero Viewpoint Wireless Touch Panels